This is tutorial number 1 from our series of Arduino tutorials and in this part I will talk about blinking an LED using the one already available on the Arduino Uno board or using an external LED to ...

4. Connect the breadboard rails to Arduino GND and +5V, and then check that your setup matches that of Figure 10-3. Mounting the Laser. For this project, I’ve attached the servos to a pan-and ...

The Julia programming language is a horrible fit for a no-frills microcontroller like the ATMega328p that lies within the classic Arduino, but that didn’t stop [Sukera] from trying, and succe… ...

This goes through an OR gate and an inverter to drive pin 13 of my Arduino (the LED built into the board). The net effect is the LED will blink unless you turn the virtual switch on the MyOpenLab ...