Shown below is the basic hardware setup diagram. Here, Arduino’s (Uno R3) A4 (SDA) and A5 (SCK/SCL) pins are used for the I2C control, and the module is 3.3 V powered by the Arduino itself. It seems ...

An Arduino runs the show, using a microphone module to listen out for loud noises such as claps. If two claps are detected in the nominated timeframe, the machine begins to flash its “APPLAUSE ...

The Giga Display Shield (plug-in board) might fit the bill. It adds a 3.97inch 480 x 800 RGB touchscreen, digital microphone (MP34DT06JTR by ST), six-axis IMU (Bosch BMI270 inertial measurement unit), ...