Although we tend to think of 3D printers as high-tech toys, most of them are not especially powerful in the brain department. There are some exceptions, but most 3D printers run on either an 8-bit … ...

Switch on the 3D printer and browse to the IP address of the Raspberry Pi to access the Mainsail front-end we had chosen for Klipper. Browse to the "Machine" menu on the left-hand side panel and ...

While the Raspberry Pi has very good support for an I2C bus, a lot of very cool chips – including the in system programmer for just about every ATtiny and ATmega microcontroller – use a… ...

A clever hack by two Digital Harbor Foundation (DHF) students was on display last week during the one-year anniversary of the Digital Harbor Tech Center. Two DHF youth members Birendra Rai and Glory ...