In this circuit, we are making a Light Sensor using LDR with Arduino to control a bulb/CFL as per light condition of the room or outside area. Material Required. Arduino UNO; LDR ... SCHURTER's ...

Light sensor Dark sensor. Light and dark detection using an LDR. For this project, let’s stick to the LDR sensor module so we can select the light or dark detection by placing jumpers. We’ll be using ...

IR Sensor Pinout. The IR sensor has a 3-pin connector that interfaces it to the outside world. The connections are as follows: VCC is the power supply pin for the IR sensor which we connect to the 5V ...

Connect the A0 pin of the Arduino to the same column where the LDR and resistor is connected (Since the LDR gives out an analog voltage, it is connected to the analog input pin on the Arduino. The ...

The hardware is consists of an Arduino microcontroller (here an Arduino Uno R3) and a pre-wired soil moisture sensor module. The soil moisture sensor module , built around the LM393 comparator, gives ...

As stated, the circuity can be used to send calibrated pulses to a microcontroller-based tacho meter or similar circuit/device. The wiring of the hardware turned out to be deceptively simple. At the ...

Nevertheless, this could be a handy sensor, and it’s definitely a solid lesson in design. Still, if your tastes run more toward using this module on the 1.25-cm ham band, have a look at this ...

Connect the A0 pin of the Arduino to the same column where the LDR and resistor is connected (Since the LDR gives out an analog voltage, it is connected to the analog input pin on the Arduino. The ...